Why Marey GA5FLP Water Heater ignition failed after opening?
If the ignition failed after opening your Marey Water Heater, it might be because the gas pressure is not suitable. Ask maintenance personnel to check the water supply valve and water pressure adjusting valve.
What to do if my Marey GA5FLP water is not hot enough?
If the water from your Marey Water Heater isn't hot enough, it might be due to improper operation of the water temperature adjusting valves. Turn the water and gas controlling valves to the correct position to adjust the temperature.
Why does my Marey GA5FLP flameout during usage?
Your Marey Water Heater might flameout during usage because the main gas valve is not completely opened. Ensure the gas valve is fully open, or replace the gas tank. Another potential cause is air inside the gas pipe. To resolve this, continuously open and close the hot water valve until the flame ignites.
What to do if my Marey Water Heater main cold water supply is not opened?
If the main cold water supply is not opened, fully open the main water supply valve.
What to do if my Marey GA5FLP Water Heater cold water pressure is not sufficient?
If the cold water pressure of your Marey Water Heater is not sufficient, ask maintenance personnel to check the water pressure.
General| Type | Tankless |
|---|---|
| Power Source | Electric |
| Fuel Type | Electric |
| Flow Rate | 5.0 GPM |
| Ignition | Electronic |
| Material | Stainless Steel |
| Installation Type | Wall Mounted |
Specific warnings and guidelines for safe installation and operation.
Step-by-step guide for securely mounting the water heater.
Details on connecting the cold water inlet supply to the unit.
Instructions for connecting the hot water outlet pipe from the unit.
Guidance on correctly connecting the gas supply line to the water heater.
Steps for properly installing the exhaust pipe for safe gas venting.
To Next Page
