Hot Water
Cold Water
Outlet Valve
Inlet Valve
Gas Valve
Gas
24
STARTING STEPS:
①. Turn on the power switch.
②. After conrming power is on, press the remote
control power button.
③. Open the inlet water valve and gas valves.
④. Open the water valve (hot water tap), the
water heater will ignite and work, and hot water
will ow out.
⑤. During the operation of the water heater, if the
power supply suddenly stops, the water heater
will stop working and close the gas valve. When
the power is reset, the water heater with the
remote control can be started by the remote
control, and the water heater without the remote
control can be started after re-opening the water.
⑥. Power failure before operation, the water
heater can not start to provide hot water service.
- DO NOT SPRAY IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION
- DO NOT USE OR STORE FLAMMABLE MATERIALS IN OR NEAR THIS APPLIANCE
- DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE
- DO NOT MODIFY THIS APPLIANCE
WARNING
7. NORMAL OPERATION
1. Once the above
checks have been
completed, please
clean filter of any
debris (refer to p.24).
2. Fully open the
manual water
control valve on the
water supply line.
3. Open a hot
water tap to verify
that water is
flowing to that
tap.
4. Fully open the
manual gas control
valve installed.
5. Turn un the 110V
60Hz power supply
to the water heater.
6. Now you are
ready to enjoy
hours of endless
hot water.
To Next Page
Loading...
Need help?
General
