29
THE FOLLOWING CONDITIONS ARE NOT A FAULT
PHENOMENON
REASON AND HANDLING METHOD
Exhaust white smoke.
Outdoor temperature is too low, the exhausted smoke
encountered in the cold air and then condensing into
a white mist.
Flow rate of
generated hot water
is too small to achieve
expected water
temperature.
Hot water is too small to ignite the water heater, the water heater will turn
off in the situation, then water will become cold. So please do not turn the
hot water to be too small.
Can't supply high
temperature hot water
in winter.
The supply water temperature is very low and the water adjustment knob is
already turned to be maximum, the setting temperature may be more than
the heating capacity, then please adjust water supply to be smaller.
Summer failed to
supply low
temperature hot
water.
Supply water temperature is too high, and the setting a low temperature
but the inlet water is too small, it may cause the hot water temperature to
be too high, then please adjust the amount of water properly more.
minutes the water
heater suddenly
ameouts.
In order to prevent hypoxia, some models have 40 minutes timer protection
function, when you continuously use after 40 minutes will automatically
turn off. Please turn off the tap after a while and then restart.
Close the hot water
valve, but the fan
does not stop
immediately.
This is the fan has a delay in the shutdown function, in order to completely
clean the water heater exhaust to ensure the safety of users.
Open the hot water
valve, can't ow out
hot water
immediately.
It has a distance from the water heater to the hot water valve, because the
water pipe has some cold water, it takes some time for the cold water to
ow out and then comes the hot water. The farther the distance from the
pipeline, the more time it takes to wait.
It always has some
water out from drain
valve.
This is because the inlet water pressure is too high, drain valve will work to
release the high pressure (p.17)
try to reduce the in let water pressure by turning down the gate valve or the
ball valve (refer to 4.9) until water leakage stop.