4.3 SELECTING SUITABLE LOCATION FOR INSTALLATION
Carefully read this section before installation and selecting the location for installing the water
heater. The following precautions should be considered.
13
- This is a water heating apparatus only and the delivered water quality is dependent upon
the quality of water supplied to this system.
- Although the water heater is designed to operate with minimal noise level, you should not
install the unit on a wall adjacent to a bedroom, or a room that is intended for quiet study or
meditation, etc.
- Locate your heater close to a drain where leakage will not do damage to surrounding areas.
- As with any water heating appliance, the potential for leakage at some time in the life of
the product does exist.
WARNING
- Take proper care to warn occupants of the building and the public of any injury that may
occur from falling tools, open trenches, water connections or any other general hazard.
- Make sure the water heater will have sufcient room to expel combustion air and operate
with natural ventilation.
- Keep the area around the water heater clean. Particles may clog the air vent, reduce fan
function, or cause improper combustion.
- Locate the unit for easy access and maintain clearance for service and maintenance. Install
the unit so that it can be connected or removed easily.
- The water heater must be installed outdoors only. Do not install the water heater indoors.
- Not to be used as a swimming pool heater.
- Do not locate your water heater in a pit or any location where gas and water can accumulate.
- Please check the proximity of gas & electrical connections so as not to create a hazard and
avoid access problems for other services.
- It must be located in accordance with the requirements clearances from eaves, windows,
vents etc. –And see the diagram on the p.12~13. for more surrounding construction material
requirement.
- Do not place ammable or explosive materials within one meter of the water heater to avoid res;
- This relates to the physical separation distance specication where multiple appliances are
employed. That equates to a minimum 150mm horizontal ue separation distance allowing
appliances to be placed side by side in the same vertical plane
- Most load bearing walls such as brick, brick/veneer, weatherboard and stud-frames are
suitable locations.
- Securely fasten the unit to the wall with screws or bolts in the top and bottom brackets.
- And see the diagram on the p.12~13. for more surrounding construction material requirement.
WARNING
To Next Page
Loading...
Need help?
General
