marinco Charge Pro 27101 User Manual

502-2 & 503-2 instructions
instruction manual
marinco.com
1.1 and 4.3 AMP
Charge Pro™ Portable Chargers
MODELS: 27101 and 27104
The Marinco 27101 and 27104 chargers are designed to recharge, maintain
and extend your battery’s life in applications where your battery is stored for
long periods of time. These chargers are very versatile with selectable battery
chemistries, voltages and connectors for your battery. The chargers operate on
115 Volt, 60 HZ AC and show the charge level of your battery.
WARNING THIS CHARGER SHOULD BE USED TO CHARGE ONLY 6 OR 12
VOLT DC LEAD ACID, AGM OR GEL CELL TYPE BATTERY SYSTEMS. USE
ON OTHER THAN 6 OR 12 VOLT DC SYSTEMS CAN CAUSE THE BATTERY
TO EXPLODE AND CAUSE PERSONAL INJURY.

marinco Charge Pro 27101 Specifications

General

Input Voltage	120 VAC
Output Voltage	12 VDC
Output Current	10 Amps
Number of Banks	1
Compatibility	12V Batteries
Cooling	Fan Cooled
Battery Type	AGM, Gel
Charging Stages	3
Protection Features	Reverse Polarity, Over-Voltage, Over-Temperature

Summary

Important Safety Instructions

General Charger Safety Practices

Adhere to safety guidelines for charger operation, cord handling, and preventing damage.

Extension Cord Usage Guidelines

Use correctly rated extension cords of appropriate gauge and condition for safe operation.

Explosive Gas and Personal Safety

Explosive Gas Warning

Batteries generate explosive gases; follow instructions to prevent ignition.

Personal Safety Precautions

Take personal precautions like wearing protection and avoiding sparks near batteries.

Charging Preparation and Setup

Pre-Charge Battery and Vehicle Steps

DC Connection Precautions

Connect DC clips to battery posts and chassis correctly, avoiding contact between clips.

Vehicle Installation Cord Safety

Operation and Safety Procedures

Vehicle Installation Safety Details

Ensure clearance from moving parts and check polarity for safe vehicle battery connection.

Outside Vehicle Connection Safety

Operational Guidelines and Troubleshooting

Ventilation and Environment Safety

Ensure sufficient ventilation and keep away from ignition sources during charging.

Battery Handling and Safety Notes

Charging A Lead Acid Battery

Battery Voltage and Chemistry Check

Charger Mode Selection

Charge Completion and Disconnection

Operating Modes Explained

12V Charging Modes

6V Charging Modes