90-13645--2 4957B-18 OUTBOARD MOTOR INSTALLATION/ATTACHMENTS
7. Reinstall plug.
a
51608
a - Plug
8. Route key switch and trim switch harness through
tiller bracket. Secure both switches to bracket with
respective nuts.
Install grommet in harness access hole.
Secure harness with harness retainer.
51624
a
b
c
d
a - Harness Retainer
b - Switch Harness
c - Tiller Bracket
d - Grommet
9. Reinstall lanyard stop switch in bracket and se-
cure with clip.
51626
a
b
c
d
e
a
a - Nuts
b - Key Switch
c - Lanyard Stop Switch
d - Trim Switch
e - Clip
10. Reconnect key switch, trim switch and remote
stop switch leads at bullet connectors. Secure
harness BLACK ground lead and tiller handle re-
mote stop switch ground lead to bracket with self-
tapping screw.
b
a
51626
a - Bullet Connectors
b - Screw
To Next Page
Loading...
