Do you have a question about the MarineTech TrollMaster Series and is the answer not in the manual?
| Brand | MarineTech |
|---|---|
| Model | TrollMaster Series |
| Category | Controller |
| Language | English |
Connect the unit to a power source, ensuring correct polarity and fuse for PRO and PRO2 models.
Connect the servo cable to the control cable, aligning the brown wire with the white mark on the plug.
Power the unit ON in IDLE mode, remove the servo arm, position it correctly, and reattach.
Test the controller by powering it on and observing servo movement from IDLE to FULL THROTTLE.
Verify servo connection; if no response, replace the servo motor or contact MarineTech for inspection.
Check battery voltage; low voltage can cause the unit to power on momentarily then off.
Information on TM-MG1 servo motors and TM-Servo Arms, including included components.
Details on hardware kits (TMXXXHRDWRKIT) and electronics units (TMXXXXUNITONLY).
Instructions for ordering parts directly from MarineTech or accessing installation guides online.
Contact MarineTech for service instructions before returning the product; follow warranty guidelines.
Product is warranted against defects for one year; excludes damage from misuse or unauthorized modification.
Loading...