User’s Guide
21
6.2 Menu Navigation
At power-up, the display will show the operation screen for whichever mode
was used last. The display will appear as one of the following:
Basic & Auto Return Modes:
Cycling Mode:
PC Mode:
Appears the same as in Basic and Auto Return modes.
Pressing menu will enter Test Parameter Setup. If a password has been
programmed, the display will prompt the following:
The password is a four digit number. The first digit in the password will be
flashing, signifying that it is active and can be incremented by pressing +. To
advance to the next digit, press –>. Change subsequent digits in the same
fashion. Once the complete password has been entered, press ENTR. If
correct, the display will enter Test Parameter Setup Mode. If the password is
incorrect, the words INCORRECT PASSWORD will flash, and the display will
revert to Operating Mode.
m
e
n
u
min m
a
xSET
S p e e d :
.
000
menu min max SET
C Y C L E S : 0 0 0 2 4
PASSW 0ORD: 000
ESC > NTRE
_
+
To Next Page
Loading...
Need help?
General
