8
1. Put the 802 on the oor
vertically or horizontally;
2. Screw the rod of the AC /
SPEAKER POLE on the 802 and
insert the rst module on the top;
3. Use the ‘long’ jack cable to connect the
‘Power Out 1” of the 802 subwoofer
to the rst module input;
4. If you have system 2 or system 4, take the second, the third and the
fourth modules and x them on the top of the rst one through the equipped
junctions (pivot) with the angle you prefer;
INSTALLATION
AC / LONG CABLE
5. Take 1 or 3 ‘short’ jack cables
and link the each module
with the close one as shown in the
table;
AC / SHORT CABLE
6. Put 1 jack cap to the uncovered output
of last module;
8. Link the power cord and turn on your
system.
7. Use the “Velcro band” to link long
cables;”
JACK CAP
STRAP CABLE
To Next Page
Loading...