Mark 8 - Manual Operation; Automatic Control

GAS INFRARED HEATERS
4
3. START-UP :
Manual operation
 Open the main gas valve.
 Switch the power on.
 Start the heater ignition cycle.
 If the flame is not lit after 45 seconds, start a second ignition cycle.
 If the flame is still not lit or goes out, close the main gas valve, switch
the power off and call your installer.
Automatic control
(MT100, MT150, MTH100 or MTH150 control module)
 Open the main gas valve.
 Switch the power on.
 Check the settings (temperature, time).
 Change module programming if necessary.
4. SHUT OFF :
 Close the main gas valve.
 Switch the power off.
5. MAINTENANCE :
 To be performed once a year by your installer, according to the
INSTALLER INSTRUCTIONS.
6. CHANGING THE GAS USED :
 For any change in the type of gas used, please contact your installer.