Mark GS+ - Combustion Air

8
C13
Single ue set horizontal
stainless steel
Fluegasexhaust The ue gas
exhaust pipes
must be made of
stainless steel.
The combustion
air inlet pipes
can be made of
stainless steel,
aluminum or
polyethylene.
When the
maximum
length of the
ue systems is
exceeded, as
shown in table
[4], the diameter
of the single ue
sets, including
extension pipes
and elbows, must
be increased by
one size.
Reducer kits:
Ø80- Ø100
5990230
Ø100- Ø130
5990240
Extension pipe
stainless steel L=500
15/25/35/40 80/125 5990581 80 5990201
60/80/100 100/150 5990585 100 5990211
135/150/200 130/200 5990589 130 5990221
Extension pipe
stainless steel L=1000
C33 Single ue set vertical
stainless steel
80 5990202
100 5990212
15/25/35/40 80/125 5990557 130 5990222
60/80/100 100/150 5990561 Elbow 45°
stainless steel
135/150/200 130/200 5990564
80 5990204
100 5990214
130 5990224
Elbow 90°
stainless steel
80 5990203
100 5990213
130 5990223
Combustionair
Extension pipe
stainless steel L=500
80 5990201
100 5990211
130 5990221
Extension pipe
stainless steel L=1000
80 5990202
100 5990212
130 5990222
Extension pipe
aluminum
80 5990532
100 5990536
130 5990540
Duct bend 45°
aluminum
80 5990534
100 5990538
130 5990544
Elbow 90°
aluminum
80 5990533
100 5990537
130 5990542