7
DESKTOP PRINTER QUICK START GUIDE
QUICK START GUIDE
GUIDE INTRODUCTION
Before diving into the printing process, please ensure that you have completed the following steps as described
in this Quick Start Guide:
● Unbox or unpack your printer, drybox, and all other components that were shipped with your printer.
● Review the safety instructions that came with your printer
Note: Please consult the Safety Sheet for explanations of the icons used in this document
● Review the Network Requirements section at the end of this Quick Start Guide
●
necessary for online printing. If you experience network issues or cannot print online at any point, a version of
Supplies
● Drybox
● Plastic feed tube
●
●
● Tweezers
● Glue stick
● Leveling shims (in envelope)
● Scraper
● 2.5mm hex key
● Wire cutters or similar tool (not included in accessory kit)
● Masking tape, painter’s tape, or similar (not included in accessory kit)
LOAD PLASTIC
Note: The print head will become hot during the plastic loading process. Exercise caution when
working near the nozzles.
Only use materials that have been approved by Markforged for use with this printer.
Series is designed to work only with proprietary materials and consumables from Markforged.
Always follow proper procedures when storing plastic materials.
much moisture from the air will often cause underextrusion, which can cause print failures. Please take special
To Next Page
Loading...
