Need help?Do you have a question about the Markforged Onyx and is the answer not in the manual?
General| Print Technology | Fused Filament Fabrication (FFF) |
|---|---|
| Connectivity | Wi-Fi, Ethernet, USB |
| Software | Eiger |
| Nozzle Diameter | 0.4 mm |
| Build Volume | 320 mm x 132 mm x 154 mm |
| Layer Height | 100 μm |
| Print Material | Onyx |
| Power Requirements | 100-240V, 50-60Hz, 750W |
| Dimensions | 584 mm x 330 mm x 355 mm |
To Next Page
