Need help?Do you have a question about the Markforged MARK TWO and is the answer not in the manual?
Defines specific terms for materials like "Onyx" and "Nylon" used in the guide.
Specifies that printers are approved only for tabletop use on a sturdy, level surface.
Ensures the power switch remains accessible at all times for safety and operation.
Details how to clean the printer's interior and exterior using specific materials.
Provides critical safety advice on avoiding burns from hot components like nozzles.
Emphasizes adherence to all posted and written safety instructions for safe operation.
Clarifies that some sections may not apply to non-fiber-capable printer models.
Lists all accessories included with the Desktop Series printer.
Lists essential external items needed for setup, like hex keys and wire cutters.
Guides users on connecting the printer via Ethernet or Wi-Fi.
Explains how to update the printer's firmware via the dashboard.
Introduces the Quick Start Guide and outlines prerequisites before beginning.
Lists the necessary supplies for the quick start printing process.
Provides step-by-step instructions for loading plastic filament into the printer.
Guides users through leveling the print bed using the Shim Bed Level utility.
Instructs on running a test print to evaluate and confirm print bed leveling.
Instructs users to log into their Eiger account via Google Chrome to begin printing.
Details how to register the printer within the Eiger platform.
Guides users to select a sample print job, "Logo Keychain Onyx," from their Eiger library.
Explains how to set the printer type and material selections within Eiger.
Instructs users to save the print configuration and start the printing process.
Provides instructions and safety warnings for removing the printed part from the bed.
Details how to clean the print bed using warm water after printing.
Specifies requirements for Ethernet connections, including cable length limits.
Outlines firewall configurations required for printer operation and connectivity.
Explains the necessity of accurate time for secure connections and the NTP protocol.
Specifies that the Google Chrome browser is required and WebSockets must be enabled.
General| Software | Eiger |
|---|---|
| Connectivity | Wi-Fi, Ethernet, USB |
| Reinforcement Technology | Continuous Fiber Reinforcement (CFR) |
| Nozzle Diameter | 0.4 mm |
| Technology | Fused Filament Fabrication (FFF) |
| Layer Height | 100 microns |
| Layer Resolution | 100 microns |
| Materials | Onyx, Carbon Fiber, Fiberglass, Kevlar, HSHT Fiberglass |
| Print Bed | Heated |
| Power Requirements | 100-240 V, 50-60 Hz |
| Weight | 16 kg |
To Next Page
