17
DESKTOP PRINTER QUICK START GUIDE
NETWORK REQUIREMENTS
WIRED CONNECTIONS
Ethernet connections must utilize cables less than 30 meters in length.
FIREWALL SETTINGS
Markforged products support DHCP only; there is no support for static IP addresses. If a static IP is needed, the
Connecting Your Printer, above.
For proper operation, printers must be able to make outbound connections to services at the following
hostnames on the given ports (no inbound connections are needed):
HOSTNAME PORT PROTOCOL REQUIRED REASON
s3.amazonaws.com
mfeiger-production.
s3.amazonaws.com
443 TCP yes Downloading .MFP part files
produced by Eiger and consumed
by printers
cdn.eiger.io 443 TCP yes Device operation
www.eiger.io 443 TCP yes Connecting to Eiger (required for
viewing printer status, queuing print
jobs, keeping printer software up to
date, etc.)
*.pool.ntp.org 123 UDP yes Time synchronization via NTP is
required for printers to connect
securely to Eiger; see Printer Time
Synchronization, below
ipv4.connman.net 80 TCP no Network connection status check
(primarily used for troubleshooting)
data.logentries.com 443 TCP no Remote logging of printer events
and errors
data.logentries.com 10000 TCP no Legacy setting for remote logging,
only required if software version is
older than 09/14/2018
To Next Page
Loading...
