DESKTOP PRINTER QUICK START GUIDE
16
8.
9. Build Settings
10. Click the Print button in the bottom right corner of the page.
11.
12. Select Print Now.
13.
14. Remove the print bed from the printer and use the provided scraper to remove the part from the print bed.
Warning: The scraper provided with Markforged printers is sharp and can cause injury if used
incorrectly.
Tip: Always scrape away from your body. When removing a part, brace the bed in a vertical position
against a sturdy level surface. Slide the scraper under the corner of the part. Always keep fingers or
other body parts out of the path of the scraper when removing a part from the print bed. Maintain an
acute angle between the scraper and the print bed while you are removing your part.
15.
Note: Do not use soaps or other cleaners, as these may damage or leave residue on the bed.
To Next Page
Loading...
