Need help?Do you have a question about the Markforged Metal X and is the answer not in the manual?
Explains FCC compliance for Class A digital devices and potential interference.
Specifies the printer is approved for tabletop use only.
Emphasizes ensuring the power switch is accessible at all times.
Lists precautions to avoid burns from hot components.
Guides through creating a new organization in Eiger software.
Explains how to add a printer to an existing Eiger organization.
Details the steps for connecting the printer to a Wi-Fi network.
Outlines the process for establishing an Ethernet connection.
States that the printer supports DHCP only, not static IP.
Lists required hostnames and ports for device communication.
Instructs to unload filament before powering off the printer.
Describes using the power switch on the back of the printer.
Details the process of updating firmware using a USB drive.
Explains how to update firmware wirelessly via Wi-Fi or Ethernet.
Guides through initiating the bed leveling process.
Explains the 16-point scan and manual screw adjustment.
Details how to turn on the vacuum to secure the print sheet.
Steps for placing and aligning the print sheet on the bed.
Checks for an engaged and stable vacuum seal.
Explains material metering and the Metered Load routine.
Alternative method for loading filament without material tracking.
Explains material metering for release filament.
Alternative method for loading release filament.
Initiating the filament unloading process.
Initiating the release filament unloading process.
Recommended temperature ranges for storage and operation.
Advice on handling spools to prevent damage.
How to configure part orientation in Eiger.
Steps for printing to an available online printer.
Instructions for printing to an offline printer via USB.
Steps for removing printed parts after cooling.
First step in troubleshooting jams.
Using a purge rod to clear the pathway.
Identifies causes and preventive measures for print head obstruction.
Cleaning instructions for the internal camera lens.
Maintenance for the wiping station brushes.
Maintenance for print head and nozzles.
Lists necessary supplies for nozzle replacement.
Steps to heat and unload material from the nozzle.
Procedures for removing and preparing the nozzle.
Lists necessary supplies for release nozzle replacement.
Steps to heat and unload release material from the nozzle.
Procedures for removing and preparing the release nozzle.
Explains brush wear and how to replace them.
Steps for adjusting belt tension using a frequency app.
Guides through the XY offset calibration process.
Steps for calibrating stepper encoders.
How to control nozzle temperatures.
How to adjust the print bed height.
Procedure to test metal filament extrusion.
Procedure to test release filament extrusion.
General| Technology | Atomic Diffusion Additive Manufacturing (ADAM) |
|---|---|
| Software | Eiger |
| Build Volume | 300 mm x 220 mm x 180 mm |
| Layer Height | 50 μm |
| Materials | 17-4 PH Stainless Steel, H13 Tool Steel, A2 Tool Steel, D2 Tool Steel, Copper, Inconel 625 |
| Connectivity | Ethernet, Wi-Fi |
| Heated Build Chamber | Yes |
To Next Page
