Página nº 8 de 25
Place the hopper as shown in the picture,
press down till the blocking device (Pos 4)
enters the hole (R) in the hopper neck.
For compliance with safety requirements,
tighten the hopper fixing screw (T) using a
5mm allen wrench.
Insert the coffee grounds tray as shown
in the illustration.
THE GROUND COFFEE SPILLED ON THIS
TRAY MUST NOT BE PUT IN THE HOPPER.
The grinder has a Ø57mm press tamp
placed in the front of the machine and
another Ø53mm press tamp is included in
the box along with the power cord and the
grounds tray. Check which one best matches
the filter-holder of your coffee machine and
change it if needed.
To Next Page
Loading...