Página nº 9 de 25
To connect the grinder to the power supply, proceed as follows:
- The grinder's electrical connection must be properly protected by current
limiting circuit breakers, a differential switch and a ground connection,
according to current safety regulations.
- Make sure that the voltage and frequency of your establishment match
those indicated on the grinder's rating plate.
- Plug the grinder into the electrical socket. The display will show the
message:
- Open the hopper lid and pour the coffee beans into the hopper. NEVER
put GROUND COFFEE in the hopper
- Make sure that the hopper closing device (Pos. 2) is open.
- Select the desired coffee dose, pressing the corresponding button:
Key F: “ 1 CUP ” o key G: “ 2 CUPS ”.
- Insert the filter-holder from your coffee machine in the filter-holder rest
(Pos. 9) as far as it will go, pressing the switch.
- The corresponding dose is deposited in the filter-holder.
- Compact this dose using the press tamp (Pos. 8) to level off the ground
coffee before placing it in your coffee machine.
- The grinder automatically grinds the corresponding dose.
- Use the ON / OFF key (Pos. D) to turn on and off the grinder. In Off
position, the grinder remains in stand-by mode.
To Next Page
Loading...