5
4.9 Retract the mini-awning completely. Set the
stop strip in the tracks. When tightening the
screws ensure that the stop strip does not twist
in the track (press when tightening).
Attention: Ensure same position on
both sides of the rails. If required align the stop
strips should they have twisted during the
tightening process.
4.10 Extend the mini-awning completely and adjust
the stop strips if required. If required, the drive
end lock has to be adjusted in extension direc-
tion for manual-driven units.
stop strip
guide tube
guide tube bracket
slide mechanism
angled guide rail
To Previous Page
Loading...
