Markilux 990 - Operation manual; Reading operating instructions; Manual awning operation

7
5. Setting the angle of inclination
5.1 Wall mount 0° - 35°
1. Extend awning and unscrew
the rear threaded pin SW 5 (1) at
both consoles by approx. 10 mm
from the consoles.
2. Set the required inclination by
turning the front threaded pin SW
6 (2) either way at both consoles
respectively. While doing this take
the pressure of the arms by lifting
them.
3.
Attention!: Tighten the rear
threaded pin SW 5 (1) again at
both consoles so that the awning
is protected against flipping up!
5.2 Ceiling mount 0° - 35°
1. Extend awning and unscrew
the rear threaded pin SW 5 (1) at
both consoles by approx. 10 mm
from the consoles.
2. Set the required inclination by
turning the front threaded pin SW
6 (2) either way at each of the
two consoles. While doing this
take the pressure of the folding
arms by lifting them.
3. If an angle of 35° is sufficient
for both consoles, tighten the
rear threaded pin SW 5 (1) again
so that the awning is protected
against flipping up!