◢MR6100 Serial UHF reader user manual（Ver 1.0）◣
Address：
Floor 3/5, Block D,Changyuan New Material Port, No 2 Central 1st Hi-tech Av., Nanshan Shenzhen, P.
R.C. Post：518057
Phone：0755-2654 6392 FAX：0755-2655 3743
E-mail：technical@marktrace.com Website：www.marktrace.com
configure between 10-990ms；When in trigger working mod, reading
maximum lasting time can be configure as 255s；
2）Read tag type can be 18000-6B or EPC G2，also can be configure read both
at same time（expand function）；
3）When read EPC tag，read area can select as EPC、TID or USER memory；
6B tag cannot select area；
4）User can select read tag‟s start address and read data length，EPC tag data
use word as unit，6B tag data use byte as unit;
5）User filter repeat tag，Filter set one slide time window，only new data which
not show in box can be buffer or direct output；
6）Read tag data can be select buffer or directly output，data buffer adapt with
power down save ferroelectric memory，storage capacity 32KBytes，when read
data length is 12Bytes，can store more than 2200pcs tag data；
3、output configuration
1）In working mode configure, when select data output as directly output mode,
user can configure output port；
2）Reader data output port have RS232、RS485、Wiegand、Ethernet and relay
output；
3）Wiegand protocol support Wiegand26 and Wiegand34；
4）Relay close delay time configurable between 0-99s；
5）For above mentioned port, user can select one type or multiple type to
output data；
6）Data output can in ASCII code and Hex format；data format see below：
To Next Page
Loading...