10
The Sender unit has a Measurement Clamp that detects export current when correctly
fitted on the live incoming supply cable from the utility meter. The unit sends
measurements wirelessly to the Solar iBoost+ unit.
3. Assembling the Sender and Measurement Clamp
A DC mains power supply is available to
purchase separately.
Contact your supplier for details.
Fit the connector from the power supply
into the socket marked on the sender.
1. Fit the plug from the Measurement
Clamp wire into the Sender.
3. Switch on the power to the Solar iBoost+.
A set up procedure runs and the 2 devices
connect automatically, usually within 30
seconds. If necessary follow the instructions
for pairing on page 16.
Note: The Sender and Solar iBoost+ units are factory paired. Do not press the
button on the sender or pairing may be lost.
Assemble the Sender
Initialising
Please Wait
2. Fit batteries (included) or DC mains
power supply (supplied separately).
When fitting batteries or DC power supply
the sender should be at least 1-2m away
from the Solar iBoost+
To Next Page
