Marsh R - Page 12

Repair
23
25004/98337 Rev C
Adjusting the
Tracking on the
Lower Feed Roller
Assembly
1. Turn the machine upside down.
2. To raise the feeding of the oilboard above a guide line, turn the inside nut
clockwise. See Figure G.
3. To lower the feeding of the oilboard below a guide line, turn the outside nut
counterclockwise. See Figure G.
4. Tighten the opposite nut after making the adjustment, but be careful not to over-
tighten it.
5. Feed the oilboard through the machine after each adjustment to test the setting of
the nuts.
Figure G
Figura G
Lower Feed Roller Assembly
Ensemble des rouleaux d’alimentation inférieurs
Conjunto de rodillos de avance inferiores
Outside Nut
Ecrou extérieur
Tuerca externa
Inside Nut
Ecrou intérieur
Tuerca interna