9. Place the stud collar about 1/16" (1.6 mm) from the base wall, but not so close that it
rubs against the wall.
10. Insert the allen wrench in the set screw of the stud collar and pull the stud collar and
spring to the right. Make sure the eccentric shaft remains inserted in the hole of the
feed roller assembly and the collar is flush with the base wall closest to you.
11. When these parts are in position and the tension on the spring is as it is shown in
Figure J, tighten the set screw to its original position.
12. Test the play of the eccentric shaft and stud collar by gently pulling on the stud
collar. Some movement should be allowed.
Repair
31
25004/98337 Rev C
To Next Page
Loading...
