BLUETOOTH
Pressing REV and POWER Section Switches together (#18 & #19 in this manual) accesses
the Bluetooth
®
pairing function:
• The display screen will show ‘Bluetooth, pairing enabled’ and your CODE amplier’s
pairing ID.
• The blue LED on EXIT/STORE (#21 in this manual) will ash while pairing.
• When paired, the blue LED will stop ashing and remain lit.
• When streaming audio, use the MASTER volume control or your music player to set the
volume level.
The Marshall Gateway™ App enables you to control your CODE amplier remotely and
access Marshall Gateway using your iOS/Android device. Download Marshall Gateway
now from the App Store or Google Play.
ENGLISH ENGLISH
STORING A PRESET (CONT.)
To rename the edited Preset and store to the current location:
• While the Preset name is ashing, press & hold EXIT/STORE again briey until the Preset
name is displayed with the cursor ashing at its rst letter
• Turn the PRESET selector to change the letter or character.
• When you have found the letter or character you want, push PRESET to select it. The
cursor will automatically move to the next character.
• Repeat until you have renamed the Preset.
The Section Switches act as naming shortcuts:
PRE FX
AMP
MOD
DEL
REV
POWER
CAB
Clear
Number
Upper / Lower Case A
Upper / Lower Case
Space
Backspace
Cancel
NAMING SHORTCUTS
• To complete the store process, press & hold EXIT/STORE once more until STORED
appears on the display screen. Your edited Preset has now been stored to CODE’s
memory.
EDITING A PRESET
To edit PRE FX, AMP, MOD, DEL, REV,
POWER and CAB section settings:
• Hold down the Section Switch that you
wish to edit (#14 - #20 in this manual) –
the switch LED will light green.
• The display screen will show the current
preamp, FX, power stage or speaker cab.
• Turn the PRESET selector (#8 in this
manual) to scroll through the section’s
preamps, FX, power stages or speaker
cabinets.
• When you have found the preamp, FX or
power stage that you want to edit, push
the PRESET selector to begin editing.
• The display screen will show the
parameter and its current value.
• To edit the parameter value, turn the
PRESET selector.
• To move to the next parameter (if there is
one), press the PRESET selector.
• To edit that parameter value, turn the
PRESET selector.
• Repeat for all parameters and parameter
values of the Sections that you wish to
edit.
• When you are happy with your edited
Preset you can store it to your CODE
amplier’s memory.
• If you wish exit without storing your edits,
press EXIT/STORE (# 21 in this manual).
This will return you to the main Preset
screen.
• Scroll away from the Preset and it will
revert to its last stored settings.
STORING A PRESET
To store an edited Preset, Store an edited Preset to a new location, and to rename an
edited Preset:
• When you have nished editing, press & hold EXIT/STORE briey until the Preset name
begins to ash.
• If you wish to store your edited Preset to another location, turn the PRESET selector to
nd a new location, then press & hold EXIT/STORE until STORED appears on the display
screen.
Speaker cabinet models are not
editable.
!
To learn how to store an edited Preset,
refer to STORING A PRESET in this
manual.
!
If you wish to keep your edited settings
ensure that you store before moving off
that Preset.
!
Be sure that you want to store to the Preset location that you have selected, as the Preset
in that location will be overwritten.
!
Audio streamed via Bluetooth will bypass CODE’s panel features, with the exception of
MASTER volume.
!
To Next Page
Loading...
Need help?
General
