ENGLISH ENGLISH
GUITAR TUNER
Pressing the PRE FX and AMP Section Switches (#14 & #15 in this manual) together
accesses the guitar TUNER:
• Pluck a string and the note you are playing will display.
• Tune the string until the name of the note you wish to tune to appears on the screen.
• Arrows to the left of the vertical line means the note is at; arrows to the right of the
vertical line means the note is sharp.
• When the arrows disappear, that string is tuned to the displayed note.
• Press EXIT/STORE to exit the Tuner.
FACTORY RESET
Performing a factory reset will return CODE’s Presets back to when it was new.
To perform a factory reset:
• Power OFF the amplier using the ON/OFF switch (#13 in this manual).
• Whilst holding down the AMP Section Switch, turn the power ON.
• The screen will display a notication that the amplier is about to be returned to its
factory settings.
• If you are sure that you want to perform a factory reset, press and hold the EXIT/STORE
switch to conrm.
• If you do not want to restore the factory presets, pressing any other switch will cancel the
factory reset operation and boot the amplier as normal.
A:>>|<<
DECLARATION OF CONFORMITY
Before performing a factory reset, be sure that you want to overwrite all of your personal
Presets.
!
Manufacturer:
Marshall Amplication Plc,
Denbigh Road,
Bletchley,
Milton Keynes,
Bucks,
United Kingdom
MK1 1DQ
Kind of equipment: Audio Equipment
Type designation: CODE25, CODE50
We, Marshall Amplication Plc, declare under our sole responsibility that the above listed products complies with the following
Directives:
1. EMC Directive 2014/30/EU;
2. Low Voltage Directive (LVD) 2014/35/EU;
3. R&TTE Directive 1999/5/EC.
The following harmonised standards have been applied:
1. EMC
• EN 55013:2013
• EN 55020:2007+A11:2011
• EN 61000-3-2:2014
• EN 61000-3-3:2013
2. LVD • EN 60065:2014
Health &
Safety
(Article 3(1)(a))
• EN 62479:2010
• EN 60065:2002 + A1:2006 + A11:2008 + A2:2010 +A12:2011
EMC
(Article 3(1)(b))
• ETSI EN 301 489-1 V1.9.2:2011
• ETSI EN 301 489-17 V2.2.1:2012
Spectrum
(Article 3(2))
• ETSI EN 300 328 V1.9.1:2015
3. R&TTE
Signature: Name: B. Moon Date: 2nd May 2016
Name of the responsible party: Jam Industries USA, LLC
Address of the responsible party: 1649 Barclay Blvd, Buffalo Grove, IL 60089, United States of America.
Telephone number of the
responsible party:
800-877-6863
Name of equipment: MD116D Guitar Ampliers
Model No.: CODE25, CODE50
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
16
To Next Page
Loading...
Need help?
General
