Marshall Amplification DSL100HR - Rear Panel Connections - Secondary; Loudspeaker Outputs and Impedance; MIDI Implementation Chart

33. LOUDSPEAKERS
There are ve speaker outputs available.
They are labelled according to the
intended impedances:
• 1 x 16 OHM: connect a single 16 Ohm
speaker cabinet to this jack.
• 1x 8 OHM or 2 x 16 OHM: connect a
single 8 Ohm speaker cabinet or two 16
Ohm speaker cabinets.
• 1 x 4 OHM or 2 x 8 OHM: connect a
single 4 Ohm speaker cabinet or two 8
Ohm speaker cabinets.
WARNING: Although the amplier has ve
speaker outputs, never attempt to connect
more speaker cabinets than rated. The safe
combinations are: 1 x 16 Ohm, 1 x 8 Ohm, 2 x
16 Ohm, 1 x 4 Ohm or 2 x 8 Ohm only. Any other
speaker cabinet conguration may stress the
power amplier section and in extreme cases may
lead to valve and/or output transformer failure.
NEVER use DSL100HR or DSL40CR without a
speaker load.
REAR PANEL FUNCTIONS (CONT.)
ENGLISH ENGLISH
MIDI IMPLEMENTATION CHART
FUNCTION TRANSMITTED RECOGNISED REMARKS
MIDI Channels N Y (1-16) Default receive channel 1
Note Numbers N N
Program Change N Y (0-127) Amp channels mapped to
every four PC values
Bank Select Responce N
Modes Supported:
Mode 1: Omni-On, Poly N
Mode 2: Omni-On, Mono N
Mode 3: Omni-Off, Poly N
Mode 4: Omni-Off, Mono N
Multi Mode N
Note-On Velocity N N
Note-Off Velocity N N
Universal System Exclusive N N
Manufacture System Exclusive N N
FUNCTION # TRANSMITTED RECOGNISED REMARKS
13 N Y LOOP
0 = Off
1 = On
2-127=Toggle State
14 N Y Master
0 = Off
1 = On
2-127=Toggle State
1. BASIC INFORMATION
FUNCTION TRANSMITTED RECOGNISED REMARKS
MIDI Clock N N
2. MIDI TIMING AND SYNCHRONIZATION
MIDI IMPLENATION CHART CONTROL NUMBER INFORMATION
MANUFACTURER: Marshall
VERSION: 1.1
MODEL: DSL 40 & DSL 100
DATE: 24.08.17
MANUFACTURER: Marshall
VERSION: 1.1
MODEL: DSL 40 & DSL 100