EasyManua.ls Logo

Marshall Amplification DSL40CR User Manual

Marshall Amplification DSL40CR
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
DSL40CR
DSL100HR
QUICK START GUIDE

Other manuals for Marshall Amplification DSL40CR

Question and Answer IconNeed help?

Do you have a question about the Marshall Amplification DSL40CR and is the answer not in the manual?

Marshall Amplification DSL40CR Specifications

General IconGeneral
TypeTube Amplifier
Power Output40 Watts
Speaker1 x 12" Celestion Seventy 80
Channels2
Tubes2 x EL34
ControlsGain, Volume, Treble, Middle, Bass, Reverb, Presence
ReverbYes
EQTreble, Middle, Bass, Presence
Inputs1 x High, 1 x Low
Outputs1 x 8 Ohm, 1 x 16 Ohm
Footswitch I/O1 x 1/4" Jack
Effects LoopYes

Summary

Warning Safety Instructions

Mains Input and Fuse

Details on power connection, voltage rating, and fuse replacement procedures.

Important Set Up Information

Steps for safely switching on the amplifier and connecting external equipment.

Transporting Your Equipment

Guidelines for safely moving the amplifier, including disconnecting cables.

FCC Compliance Statement

Statement regarding compliance with FCC rules for radio frequency interference.

Specifications Overview

Front Panel Functions

Classic Gain Channel Controls

Details on Gain, Volume, and Mode selection for the Classic Gain channel.

Ultra Gain Channel Controls

Details on Gain, Volume, and Mode selection for the Ultra Gain channel.

Equalisation Controls

Explains EQ knobs: Treble, Middle, Bass, Tone Shift, Presence, Resonance.

Front Panel Functions Continued

Reverb Section Controls

Controls for adjusting reverb levels on the Classic and Ultra channels.

Master Volume Controls

Explains Master Select, Master 1, Master 2, and status LEDs.

Output and Power Controls

Details on the Output power reduction switch and the Power switch.

Rear Panel Functions

Mains Input and Voltage

Location for power lead connection and identification of mains voltage rating.

MIDI In Port

Port for connecting external MIDI devices for control.

FX Loop Connections

Ports for connecting external effects units via Send and Return jacks.

Footswitch and Audio Inputs

Connections for footswitches and external audio devices for practice.

Emulated Output

Frequency-compensated line level output with cabinet emulation for headphones.

Speaker Outputs

Ports for connecting speaker cabinets with specific impedance requirements.

Starting Settings Suggestions

Classic Clean Tone

Recommended settings for achieving a clean tone on the Classic Gain channel.

Classic Crunch Tone

Recommended settings for a crunch tone on the Classic Gain channel.

Modern Drive Tone

Recommended settings for a modern drive tone on the Ultra Gain channel.

Blues Lead Tone

Recommended settings for a blues lead tone, utilizing Ultra Gain.

Scooped Rhythm Tone

Recommended settings for a scooped rhythm tone with specific EQ adjustments.

Related product manuals