Marshall Amplification DSL40CR User Manual

ENGLISH
3
Warning: Please refer to full details in separate
ImportantSafetyInstructionsCATS-90009.
Warning: beforegoinganyfurther,makesure
that your amp is compatible with your mains
electricity supply. If you have any doubt, please
seekhelpfromaqualiedtechnician–your
Marshall dealer can help you with this.
MAINS INPUT & FUSE
Thespecicmainsinputvoltageratingthatyour
amp has been manufactured for is indicated
on the rear panel of the amp. Never attempt to
bypassthefuseortoneoftheincorrectvalue
or type.
Warning: your amp must be switched off and
disconnected from the mains electricity supply
beforeyoucheckand/orchangeanyfuse.
IMPORTANT SET UP INFORMATION
Follow the start-up procedures below to safely
switch on your amp.
Warning: Failure to follow these instructions may
damage your amp.
1. If using your amp with an extension cabinet,
makesurethepowerhandlingratingofthe
speakercabinetisequaltoorhigherthan
the output power of the amp. Connect
eitherasingle16Ωspeakercabinettothe
singlespeakeroutputontherearpanel,or
asingle8Ωspeakercabinetortwo16Ω
speakercabinetstothepairof8Ωspeaker
outputs.
Note:Whenconnectingaspeakercabinet
makesurethatyouuseaproperspeaker
cable. Never use a screened (shielded)
guitar cable for this purpose.
2. Ensure the power switch is switched off and
set all master volumes on the front panel
to zero.
3. To use the footswitch, connect the
footswitchcabletothefootswitchsocket
on the rear panel of the amp.
4. Connect the supplied mains (power) lead
intothemainsinputontherearpanelrst
and then into an electrical outlet.
5. Plugyourguitarintotheinputjacksocket
on the front panel.
6. Turn the front panel power switch on. The
switch will glow red. Turn the selected
channel volume up to your preferred level
and your amp is ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched off,
unplugged from the mains electricity supply and
all removable cables have been disconnected from
yourequipmentbeforeattemptingtomoveit.
Only move the amp on its own; do not attempt
tomoveitwhileitisstackedontopofacabinet
orotherequipment.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Thisequipmenthasbeentestedandfound
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
WARNING! SAFETY INSTRUCTIONS
Please read this manual carefully before plugging in. Follow all instructions and heed all
warnings.

Marshall Amplification DSL40CR Specifications

General

Brand	Marshall Amplification
Model	DSL40CR
Category	Amplifier
Language	English