Marshall Amplification DSL40CR - Rear Panel Functions; Mains Input and Voltage; MIDI In Port; FX Loop Connections

ENGLISH
7
26. MAINS INPUT
The supplied mains power lead is connected here.
The mains input voltage rating that your amp has
been built for is shown on the rear panel.
Warning: before powering on, ensure the
amp is compatible with the mains voltage of
the country that the amp is being used in. If
you have any doubt, please get advice from a
qualiedperson.
27. MIDI IN
Connect your external MIDI device here.
28. FX LOOP RETURN
ReturnyoursignalfromexternalFXequipment
hereusinga¼”jackinstrumentcable.
29. FX LOOP SEND
ConnectyourexternalFXequipmenthereusing
a¼”jackinstrumentcable.
30. F/S
Connect the supplied channel footswitch here
(PEDL-90012)oroptionalfootswitch(PEDL-
91016).
31. AUDIO IN
Connect an external device here to practice
with or jam along to music.
32. EMULATED OUT
Frequency-compensatedlineleveloutputfor
headphones. This output features cabinet
emulation by Softube®. This means the sound
from this output includes simulation of the
soundofaspeakerandacab.
33. SPEAKER OUTPUTS
1/4”jackspeakeroutputs.Theyarelabelled
according to the corresponding cabinet setups:
• 1x16Ohm:connecta16Ωspeakercabinet.
• 1x8Ohm/2x16Ohm:connectasingle
8Ωguitarcabinetortwo16Ωcabinets.
REAR PANEL FUNCTIONS
• 1x4Ohm/2x8Ohm:connectasingle4Ω
guitarcabinetortwo8Ωguitarcabinets.
Warning:althoughtheamphasvespeaker
outputs, never attempt to connect more
speakersthanrated.Thesafecombinationsare
listedabove.Anyotherspeakerconguration
may stress or damage the amp.