ENGLISH
7.0
FACTORY RESET
MIDI RESET
Warning: once the memory is erased it cannot
be recovered.
To erase all the MIDI pre-sets and set the MIDI
reception channel to #1:
1. Ensure the amp is completely turned off.
2. Press and hold clean/crunch channel
switch.
3. Switch the amp on (power switch on, not
standby switch). The 2 channel LEDs will
glow red.
4. Release the switch.
5. To conrm the factory reset press
overdrive mode switch. If you want to
abort, press any other switch.
FOOTSWITCH RESET
Warning: once the memory is erased it cannot
be recovered.
To reset the footswitch to the factory default
status:
1. Unplug the footswitch at any of the cable
sides.
2. Press and hold the switch #4 (right switch).
3. Plug in the footswitch cord.
4. Release the switch and the FX LED will
start blinking.
5. If you want to erase the footswitch
memory press the switch #3. To keep the
memory press either the #1 or #2 switch.
6. Release the switch and the footswitch will
synchronise with the amp.
The factory default is as follows:
FSW #1: clean/crunch mode;
FSW #2: overdrive mode;
FSW #3: master;
FSW #4: reverb.
To Next Page
Loading...
Need help?
General
