Marshall Amplification MF350

Marshall Amplification plc
Denbigh Road, Bletchley, Milton Keynes, MK1 1DQ, England
Tel : [01908] 375411 Fax : [01908] 376118
www.marshallamps.com
Whilst the information contained herein is correct at the time of publication, due to our policy of constant improvement
and development, Marshall Amplification plc reserve the right to alter specifications without prior notice.
BOOK-00072-00 / 10 / 02
MF350
OWNERS MANUAL
MODEFOUR

Marshall Amplification MF350 Specifications

General

Power Output	350 Watts
Speaker Configuration	None (Head Unit)
Channels	2
Impedance	4 Ohms
Inputs	1 x Instrument Input

Summary

Important Safety Instructions

Essential Safety Warnings

Critical safety instructions covering electrical, operational, and environmental hazards for amplifier use.

Front Panel Controls: AMP 1

Tone Shaping and Volume Controls

Details the BASS, MIDDLE, TREBLE, SCOOP, VOLUME, and REVERB controls for AMP 1.

Master Section Controls

AMP 2 Controls: Gain, Tone, and Modes

Gain, Tone Matrix, and EQ

Covers GAIN, TONE MATRIX, BASS, MIDDLE, and TREBLE controls for AMP 2.

Rear Panel Connections

Main Input, Speaker Outputs, Footswitch

Details the MAINS INPUT, SPEAKER OUTPUTS, and FOOTSWITCH connections on the rear panel.

Tuner Out, Load Protection, and FX Loop

Emulated Line Outputs

Cabinet Options

Cabinet Impedance Requirements

Specifies the minimum 8 Ohm load requirement and recommended setups for cabinets.

Frequently Asked Questions

Using External Preamps and Cabinets

Silent Recording and Emulated Outputs

Troubleshooting Guide

Common Symptoms and Solutions

Provides a table of symptoms like no power, no sound, and feedback with their causes and solutions.

Load Protection and Reverb Issues

Addresses troubleshooting for LOAD PROTECTION circuit activation and digital reverb non-functionality.

Technical Specifications

Power Output and Impedance