Need help?Do you have a question about the Marshall Amplification MINI JUBILEE 2525H and is the answer not in the manual?
General| Wattage | 20W |
|---|---|
| Preamp Tubes | 3 x ECC83 |
| Power Tubes | 2 x EL34 |
| Effects Loop | Yes |
| Type | Tube |
| Channels | 2 |
| EQ | Bass, Middle, Treble |
| Inputs | 1 x 1/4" |
| Outputs | 1 x 1/4" |
| Speaker Outputs | 1 x 16 Ohm |
Essential safety guidelines for amplifier use and setup, covering mains compatibility and fuse replacement.
Step-by-step guide for connecting and operating the amplifier safely, including power-up sequence.
Connects your guitar to the amplifier using a screened cable to prevent noise interference.
Adjusts input sensitivity for clean/crunch and lead channels; pull switch activates Rhythm Clip.
Controls the output level of the Lead Channel when it is active.
Indicates when the Lead Channel is selected by lighting up red.
Adjusts preamp output and allows channel switching via footswitch or push/pull function.
Adjusts the amount of upper frequencies in the sound for tone shaping.
Adjusts mid-range frequencies, offering scooped or fatter tones.
Adjusts the low frequency content in the sound.
Adjusts amplifier 'brightness' independently of EQ settings.
Selects output power (20W/5W) and standby mode for valve warm-up.
The main on/off switch for the amplifier's power supply.
Connects the amplifier to the mains power supply, includes integrated fuse compartment.
Protects internal circuitry; located in a panel-mounted fuse holder for replacement.
Connects external effects units or external power amps.
Connects the supplied channel footswitch for channel selection.
Frequency compensated line level output for feeding into slave amplifiers or mixing desks.
Connects speaker cabinets with specified impedance ratings; critical for operation.
To Next Page