Need help?Do you have a question about the Marshall Amplification JVM410H and is the answer not in the manual?
General| Power Output | 100W |
|---|---|
| Channels | 4 |
| Preamp Tubes | 4 x ECC83 |
| Power Tubes | 4 x EL34 |
| Type | Guitar Amplifier Head |
| Effects Loop | Yes |
| Footswitch | Yes |
| Reverb | Digital Reverb |
| EQ | 3-band EQ (Bass, Middle, Treble) |
Details the 4 channels, 3 modes each, and front panel controls.
Explains the programmable footswitch and its features.
Assigns footswitch buttons to front panel functions.
Programs footswitch buttons to recall panel settings.
Discusses the 100 Watt power-stage and its controls.
Describes the studio quality reverb and its controls.
Explains the standby function for silent recording.
Describes the input jack for guitar cable connection.
Details the three modes (Green, Orange, Red) of the Clean channel.
Explains the three modes (Green, Orange, Red) of the Crunch channel.
Details the three modes (Green, Orange, Red) of the OD1 channel.
Details the three modes (Green, Orange, Red) of the OD2 channel.
Covers master volume, presence, and resonance controls.
Discusses channel-specific reverb level controls.
Explains the master volume controls and their recall.
Details power-stage EQ controls for tone shaping.
Explains the FX loop function and its controls.
Describes the dual function of the switch for programming.
How to store amplifier status as presets on the footswitch.
How to map footswitch buttons to front panel switches.
Explains how to configure MIDI reception channel and presets.
Details the standby mode for silent recording.
Connects the amplifier to the mains electricity supply.
Connects external MIDI gear and allows daisy chaining.
Connects the supplied Stompware® footswitch.
Details the 5 speaker outputs and impedance matching.
Provides a processed signal via a speaker cabinet emulator.
Connects before master volume for line level effects.
Connects external FX gear to SEND/RETURN jacks.
Resets MIDI presets and reception channel to default.
Restores factory settings for the footswitch memory.
To Next Page