Need help?Do you have a question about the Marshall Amplification ORIGIN 5 COMBO and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Controls | Volume, Tone, Gain |
| Power Tubes | 1 x EL84 |
| Effects Loop | No |
| Color | Black |
| Type | Valve Combo |
| Power Output | 5W |
| Speaker Size | 10 inches |
| Inputs | 1x 1/4" |
| Outputs | 1 x 1/4" |
Details on mains voltage compatibility, fuse type, and connection procedures.
Step-by-step guide for initial amplifier setup and operation.
Instructions for safely moving the amplifier, including unplugging.
Lists the preamp and power valves utilized in the amplifier.
Specifies the type and size of the speaker fitted to the amplifier.
Describes the two-way power output switch for high and low modes.
Explains the control for adjusting tone between different voices.
Lists the available EQ controls: treble, middle, and bass.
Details features controlled by a footswitch, such as gain boost.
Describes the input jack for connecting a guitar using an instrument cable.
Explains the volume control and the pull boost feature for gain.
Details the tilt control for tonal flexibility and voice adjustment.
Controls the lower frequency response of the sound.
Controls the middle frequency response of the sound.
Controls the higher frequency response of the sound.
Indicates when the unit is switched on.
Adjusts the output power level between low and high settings.
Used to turn the amplifier on and off.
Socket for connecting the amplifier to the mains power lead.
Connection point for the internal speaker.
Receives signal from external effects processors.
Sends signal to external effects processors.
Socket for connecting a footswitch to control functions.
To Next Page