Need help?Do you have a question about the Marshall Amplification DSL1CR and is the answer not in the manual?
General| Brand | Marshall Amplification |
|---|---|
| Model | DSL1CR |
| Category | Musical Instrument Amplifier |
| Language | English |
Connect your guitar using a 1/4" jack instrument cable.
Switch between classic gain (green light) and ultra gain (red light) channels.
Controls the volume level of the classic gain channel.
Includes Gain for distortion level and Volume for channel output.
Reconfigures preamp EQ for a different sound, accentuating highs/lows.
Adjusts higher frequencies for a brighter sound.
Adjusts middle frequencies, affecting tone and 'scooping'.
Controls lower frequencies, increasing bottom-end fullness.
Adjusts the overall reverb level of the sound.
Turns the amplifier on and off.
Connects the supplied mains power lead. Ensure voltage compatibility.
Connects external FX pedals or processors for signal routing.
Connects the supplied channel footswitch (PEDL-90011).
Connects an external device for practicing or jamming along to music.
Line level output with cabinet emulation for headphones or recording.
Reduces power from 1W down to 0.1W for lower volume operation.
Connects a 16 Ohm speaker cabinet. Use only one cabinet.
To Next Page