Need help?Do you have a question about the Marshall Amplification DSL 100H and is the answer not in the manual?
General| Type | Tube |
|---|---|
| Number of Channels | 2 |
| Total Power | 100W |
| Channels | Classic Gain, Ultra Gain |
| Preamp Tubes | 3 x ECC83 |
| Power Tubes | 4 x EL34 |
| Inputs | 1 x 1/4" |
| Effects Loop | Yes |
| Footswitch Included | Yes |
| Effects Loop Type | Series |
| EQ | Presence |
| Controls | Gain, Volume, Bass, Middle, Treble, Presence |
| Footswitch | 2-button |
| Valves | 3 x ECC83, 4 x EL34 |
Introduces the Dual Super Lead (DSL) amplifier series, highlighting its design and features.
Provides essential safety warnings and step-by-step instructions for initial setup and operation.
Details the input jack and controls for the Classic Gain channel, including gain, volume, and mode selection.
Explains the controls for the Ultra Gain channel, covering gain, volume, and mode switching.
Describes the treble, middle, and bass controls, plus the Tone Shift button for EQ modification.
Details the presence, resonance, and individual reverb controls for each channel.
Explains the power switch, standby switch for valve warm-up, and the guitar input jack.
Details the mains power connection, fuse replacement, and voltage compatibility.
Explains the Pentode/Triode switch for selecting between full (40W) and half (20W) power output.
Covers footswitch connection, FX loop functionality, and loudspeaker output configurations.
Details the power switch, standby function for valve warm-up, and reverb controls for both channels.
Explains the bass, middle, treble, presence, resonance, and tone shift controls for sound shaping.
Covers the gain, volume, and mode selection (Lead 1/Lead 2) for the Ultra Gain channel.
Details the gain, volume, and mode selection (Clean/Crunch) for the Classic Gain channel.
Specifies the input jack socket for connecting a guitar.
Details the 8-ohm and 16-ohm speaker outputs and impedance matching requirements.
Explains the footswitch jack and the send/return connections for the FX loop.
Covers the Pentode/Triode switch for power output and the mains input socket with fuse.
To Next Page