Marshall Amplification VALVESTTE AVT100

Need help?

Do you have a question about the Marshall Amplification VALVESTTE AVT100 and is the answer not in the manual?

Summary

Important Safety Instructions

WARNING: THIS APPARATUS MUST BE EARTHED!

Specific warning about earthing the apparatus for electrical safety.

General Warnings and Cautions

Covers modifications, cable use, ventilation, and plug safety for operational safety.

AVT100 Front Panel Controls

I. The Pre-amp Section

Explains controls for Clean, Overdrive 1, and Overdrive 2 channels.

II. The Master Section

Controls for the power amp section, overall volume, and presence.

Master Volume

Controls the overall amplifier volume after channel volumes are set.

Master Presence

Adjusts high-frequency control via power amp feedback.

III. FX Section

Details the effects processing capabilities of the amplifier.

A. Parallel FX Loop

Describes the rear-panel parallel FX loop for external effects units.

FX Loop Mix Control

B. Internal Digital FX

Details the built-in Digital Effects (DFX) section with multiple programs.

DFX Mix Control

Adjust Control

Program

Digital FX Program;Adjust Table

Power Switch

Turns the amplifier on and off, with anti-thump protection.

AVT100 Rear Panel Connections

Details all input and output connectors on the rear of the amplifier.

Main Input Connector

Connection point for the detachable mains power lead.

Loudspeaker Jack Sockets

Connects the internal 8 Ohm Celestion speaker.

Footswitch

Connects the supplied 4-way footswitch for channel and DFX selection.

Headphone Output

Emulated Line Output

FX Loop Connections

FX Return

FX Level

FX Send

FX Loop Hints