To Next PageTo Next Page
Need help?Do you have a question about the Marshall Amplification Valvestate 8200 and is the answer not in the manual?
General| Type | Guitar Amplifier Head |
|---|---|
| Model | Valvestate 8200 |
| Power Output | 100 Watts |
| Preamp Valves | 1 x ECC83 (12AX7) |
| Power Amp Type | Solid State |
| EQ Controls | Bass, Middle, Treble |
| Effects Loop | Yes |
| Technology | Valve/Tube Hybrid |
| Channels | 2 |
| EQ | 3-Band |
| Footswitch | Yes |
| Footswitchable | Yes |
| Speaker Outputs | 2 |
Crucial safety instructions and precautions for amplifier operation and maintenance.
Controls input volume and distortion intensity for overdrive variations.
Shifts mid-band voicing for maximum overdrive tone variation.
Describes semi-distorted sounds for rock/blues achieved via gain.
Explains Treble, Middle, Bass, and Presence tone controls for sound shaping.
Details for linking external effects processors to the amplifier.
Direct signal output from the pre-amp section for external use.
Direct access to the power stage for external pre-amps.
Filtered low-level signal for direct connection to recording/PA.
Amplifies signal to drive loudspeakers; key to unique sound.
Describes the stereo chorus effect for panoramic spread and depth.
Details for the normal channel including input, gain, EQ, and channel select.
Details for the boost channel including gain, overdrive, EQ, and contour.
Controls for the master section on models 8080 and 8100.
Controls for the master section on model 8240.
Selects level for external effects units (0dB for rack, -20dB for pedals).
Allows mixing of external effects to the dry signal.
Controls the level of reverb effect on all channels.
Controls the overall volume level of the amplifier unit.
Manual switch for chorus, also footswitchable.
Switches between flange type chorus (A) and traditional chorus (B).
Controls speed of modulation for the normal channel chorus.
Controls modulation depth for the normal channel chorus.
Controls speed of modulation for the boost channel chorus.
Controls modulation depth for the boost channel chorus.
Connection for the mains power cable.
Sockets for connecting external speaker cabinets (min 4 Ohms).
Filtered signals for direct connection to recording or mixing desks.
Connection for two-way footswitch for channel/chorus control.
Connects stereo effects processor outputs to the amplifier.
Links to the input of an external stereo effects processor.
Connects mono effects processor output to the amplifier.
Links to the input of a mono external effects processor.
Filtered left and right signals for recording or mixing desks.
Connection for two-way footswitch for channel/chorus control.
Sockets for connecting speaker cabinets (min 4 Ohms).
Filtered left and right signals for recording or mixing desks.
Connection for two-way footswitch for channel/chorus control.
Details for the normal channel including input, gain, EQ, and channel select.
Details for the boost channel including gain, contour, EQ, and volume.
Controls for master reverb, pre-amp output, power amp input, and line output.
Details for the normal channel including input, gain, EQ, and channel select.
Details for the boost channel including gain, contour, presence, and volume.
Controls for master reverb and footswitch connection.
Details input, gain, boost select, master volume, and EQ controls.
Connects headphones for private practice, muting internal speaker.
Low level output signal for recording or driving other systems.
