To Next PageTo Next Page
Need help?Do you have a question about the Marshall Amplification Valvestate VS230R and is the answer not in the manual?
General| Type | Guitar Amplifier |
|---|---|
| Model | VS230R |
| Reverb | Yes |
| Effects Loop | Yes |
| Preamp Tubes | 1 x ECC83 (12AX7) |
| Channels | 2 |
| EQ Controls | Bass, Middle, Treble |
| Outputs | Line Out |
| Footswitch | Yes |
| Technology | Hybrid (Solid State power amp, Tube preamp) |
| Power Output | 30 Watts RMS |
| Speakers | 2 x 10" Celestion Speakers |
Controls the amount of distortion on the Overdrive Channel, from crunch to high gain.
Adjusts low frequencies for the Overdrive Channel, affecting tone thickness.
Shifts mid-range frequencies, allowing for scooped mids or fuller tones.
Feeds the left-hand stereo signal to recording or PA equipment.
Feeds the right-hand stereo signal to recording or PA equipment.
Primary input for connecting your guitar using a screened cable.
Controls the volume of the Clean Channel and balances with the Overdrive channels.
Adjusts low frequencies for the Clean Channel, affecting warmth and heaviness.
Adjusts high frequencies for the Clean Channel, affecting brightness and cutting tone.
Controls gain for Overdrive 1, from blues crunch to classic rock tones.
Controls gain for Overdrive 2, increasing distortion for high gain sounds.
Shifts mid-range frequencies for Overdrive 2, enabling scooped or boosted mids.
Connection point for the mains power cable.
Feeds the left-hand stereo signal to recording or PA equipment.
Feeds the right-hand stereo signal to recording or PA equipment.
