To Next PageTo Next Page
Need help?Do you have a question about the Marshall Amplification Valvestate VS102R and is the answer not in the manual?
General| Type | Guitar Amplifier |
|---|---|
| Power Output | 100 Watts |
| Reverb | Yes |
| Effects Loop | Yes |
| Technology | Valve and Solid State |
| Footswitch | Yes (Optional) |
| EQ | Bass, Middle, Treble |
| Speaker | 12" Speaker |
| Channels | 2 (Clean and Overdrive) |
| Inputs | 2 (High and Low) |
Connect your guitar to the amplifier's input jack using a screened cable for optimal sound.
Controls the volume for the Clean Channel, affecting crunch at higher settings.
Indicates the selected channel; Red signifies Overdrive.
Adjusts low frequencies for tone warmth and heaviness, or sharpness and cut.
Controls mid-range frequencies, affecting the perceived size and fatness of the guitar tone.
Adjusts high frequencies for brighter, more cutting guitar sounds.
Allows manual switching between the Clean and Overdrive channels.
Modifies clean channel voicing, boosting mids and cutting bass.
Controls input gain and distortion for the Overdrive 1 channel, from blues crunch to classic rock.
Sets the volume level for the Overdrive 1 channel.
Switches between Overdrive 1 and Overdrive 2 channels for different distortion levels.
Controls input gain and distortion for the Overdrive 2 channel, for high-gain sounds.
Indicates selection between Overdrive 1 or Overdrive 2.
Adjusts mid-range frequencies on Overdrive 2 for scooped or fusion tones.
Controls the volume level for the Overdrive 2 channel.
Shared EQ controls for both Overdrive channels to shape tone.
Emulates saturated valve power stage sound at lower volumes.
Adjusts FX loop signal level to match effects units.
Blends effected signal with the dry signal in the FX loop.
Adds ambience and size to the guitar tone, with separate controls for channels.
Turns the amplifier's main power on and off.
Connects the amplifier to the mains power supply via a suitable lead.
Allows connection of headphones, automatically muting the internal speaker.
Connects to external loudspeakers, specifying impedance requirements.
Connects a footswitch for channel and function switching.
Input for connecting an external effects processor's output.
Output for connecting to an external effects processor's input.
Provides a direct output with speaker emulation for recording or PA systems.
