ENGLISH
2
WARNING! - Important safety instructions
WARNING: THIS APPARATUS MUST BE EARTHED!
A PLEASE read this instruction manual carefully before switching on.
B ALWAYS use the supplied mains lead, if a replacement is required please contact your
authorised Marshall Dealer.
C NEVER attempt to by-pass the fuses or fit ones of the incorrect value.
D DO NOT attempt to remove the amplifier chassis, there are no user serviceable parts.
E Refer all servicing to qualified service personnel including replacement of fuses and
valves. Servicing is required when the apparatus has been damaged in any way, such as
the power supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally or has been dropped.
F NEVER use an amplifier in damp or wet conditions.
G ALWAYS unplug this apparatus during lightning storms or when unused for long periods of time.
H Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles and at the point where they exit from the apparatus.
I DO NOT switch the amplifier on without the loudspeaker connected.
J ENSURE that any extension cabinets used are of the correct impedance.
➲
Note: This equipment has been tested and found to comply with the requirements of the EMC
directive (Environments E1, E2 and E3) and the Low Voltage directive in the E.U.
EUROPE ONLY - Note: The Peak Inrush current for the AVT150, AVT150H & AVT275 is 32 amps.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
◆
Reorient or relocate the receiving antenna.
◆
Increase the separation between the equipment and the receiver.
◆
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
◆
Consult the dealer or an experienced radio/TV technician for help.
To Next Page
Loading...
Need help?
General
