What to do if the blade is sticking on my Marshalltown Bullet MARKSMAN Power Tool?
If your Marshalltown Power Tool's blade is sticking after completing cuts, check and replace the blade stops if damaged. Ensure the blade screws are tight. You can also remove the anvil, turn it over, and reinstall it. Finally, check the anvil for marks (overbite).
What to do if Marshalltown Bullet MARKSMAN Power Tool makes rough or crushed cuts?
If your Marshalltown Power Tool is producing rough or crushed cuts, check the veneer thickness (maximum 1/16"). Inspect the blade condition for chips, burrs, or breaks. Ensure the blade is honed and sharp, and review the approved materials list.
What to do if Marshalltown Power Tool is not cutting completely through material?
If your Marshalltown Power Tool isn't cutting completely through the material, inspect the pins for oblong/wallowed orifices. For MAGNUM cutters, adjust the front stroke stop. Check the bearings for wear or play. Ensure the blade is the proper nominal height.
How to prevent blade chipping on my Marshalltown Bullet MARKSMAN?
To prevent blade chipping on your Marshalltown Power Tool, hone the blade as directed in the manual (approximately every 25 cuts, then daily). Avoid cutting stranded bamboo or high-pressure laminate. Check the veneer thickness (maximum 1/16").
Why aren't cuts square with my Marshalltown Bullet MARKSMAN Power Tool?
If your Marshalltown Power Tool isn't producing square cuts, loosen the fence screws, align the fence, and then tighten the screws. Check the pins for uneven wear. Inspect the blade and anvil/blade-stop for contact.
What to do if my Marshalltown Power Tool is not cutting to the edge of the material?
To fix your Marshalltown Power Tool not cutting to the edge of the material, check the fence alignment and adjust if needed. Avoid angling the material beyond the blade edge. Ensure angle fences are installed with the wide edge inward (620 model).
What to do if material won't fit into the cut area of my Marshalltown Bullet MARKSMAN?
If material won't fit into the cut area of your Marshalltown Power Tool, check the maximum thickness of the material for your shear. Reverse the back stroke stop. Ensure the blade is at the proper nominal height. If you have two bearings, switch which bearing is engaged.
What causes pin openings to wallow out on my Marshalltown Bullet MARKSMAN Power Tool?
To address pin openings wallowed out on your Marshalltown Power Tool, avoid lifting or carrying the shear by the handle and return the handle slowly to the open position, without letting it fly. Also, check the veneer thickness (maximum 1/16") and review the approved materials list.
How to troubleshoot cutting difficulty with a Marshalltown Bullet MARKSMAN Power Tool?
To address difficulty cutting with your Marshalltown Power Tool, ensure the cam lock is OFF. If your model is 226, engage the power lobes. Also, make sure the handle is FULLY extended, check the blade's sharpness and condition, and inspect/lubricate the bearings and pins.
What causes a bent or stuck cam lock pin on a Marshalltown Power Tool?
To prevent a bent or stuck cam lock pin on your Marshalltown Power Tool, do not lift or carry the cutter by the handle. Return the handle slowly to the open position; do not "let it fly". Disengage the cam lock pin BEFORE cutting.
Adjust anvil for easier cutting of fibrous and floppy materials.
Perform two cuts for a cleaner finish on certain materials.
Procedure for removing burrs and maintaining blade sharpness.
How to sharpen the blade to a specific knife edge.
General| Brand | Marshalltown |
|---|---|
| Model | Bullet MARKSMAN |
| Category | Power Tool |
| Language | English |
To Next Page
