Why is my Marshalltown Bullet MARKSMAN Power Tool having difficulty cutting?
If your Marshalltown Power Tool is having difficulty cutting, ensure the cam lock is OFF, and if equipped, engage the power lobes (Model 226). Also, make sure the handle is FULLY extended. Check the blade sharpness/condition and inspect and lubricate the bearings/pins.
What causes a bent or stuck cam lock pin on a Marshalltown Power Tool?
To prevent a bent or stuck cam lock pin on your Marshalltown Power Tool, do not lift or carry the cutter by the handle. Return the handle slowly to the open position; do not "let it fly". Disengage the cam lock pin BEFORE cutting.
Why is my Marshalltown Bullet MARKSMAN Power Tool not cutting to the edge of the material?
If your Marshalltown Power Tool is not cutting to the edge of the material, check the fence alignment and adjust if needed. Do not angle the material beyond the blade edge. Ensure the angle fence(s) are installed with the WIDE edge inward (620 model).
What to do if material won't fit into cut area of Marshalltown Bullet MARKSMAN Power Tool?
If the material won't fit into the cut area of your Marshalltown Power Tool, check the maximum thickness of the material for your cutter. Reverse the back stroke stop. Ensure the blade is the proper nominal height. If you have two bearings, switch which bearing is engaged.
Why is the handle not returning to open position on my Marshalltown Bullet MARKSMAN?
If the handle on your Marshalltown Power Tool is not returning to the open position, ensure the pins are lubricated. Apply grease to the contact area of the bearing. Lubricate the axle bolts and check the springs for breakage.
What to do if blade sticking after completing cuts with Marshalltown Bullet MARKSMAN?
If the blade is sticking after completing cuts with your Marshalltown Power Tool, check and replace the blade stops if damaged. Ensure the blade screws are tight. Remove the anvil, turn it over, and reinstall it. Check for marks on the anvil (overbite).
Why aren't cuts square with my Marshalltown Bullet MARKSMAN Power Tool?
If your Marshalltown Power Tool isn't producing square cuts, loosen the fence screws, align the fence, and then tighten the screws. Check the pins for uneven wear. Inspect the blade and anvil/blade-stop for contact.
How to prevent blade chipping on my Marshalltown Bullet MARKSMAN?
To prevent blade chipping on your Marshalltown Power Tool, hone the blade as directed in the manual (approximately every 25 cuts, then daily). Avoid cutting stranded bamboo or high-pressure laminate. Check the veneer thickness (maximum 1/16").
What to do if Marshalltown Power Tool is not cutting completely through material?
If your Marshalltown Power Tool isn't cutting completely through the material, inspect the pins for oblong/wallowed orifices. For MAGNUM cutters, adjust the front stroke stop. Check the bearings for wear or play. Ensure the blade is the proper nominal height.
What to do if Marshalltown Bullet MARKSMAN Power Tool makes rough or crushed cuts?
If your Marshalltown Power Tool is producing rough or crushed cuts, check the veneer thickness (maximum 1/16"). Inspect the blade condition for chips, burrs, or breaks. Ensure the blade is honed and sharp, and review the approved materials list.
Adjust anvil for easier cutting of fibrous and floppy materials.
Perform two cuts for a cleaner finish on certain materials.
Procedure for removing burrs and maintaining blade sharpness.
How to sharpen the blade to a specific knife edge.
General| Brand | Marshalltown |
|---|---|
| Model | Bullet MARKSMAN |
| Category | Power Tool |
| Language | English |
To Next Page
