EasyManuals Logo

Martin Audio EM15 User Manual

Martin Audio EM15
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
4 SAFETY FIRST
It is important that loudspeaker systems are used in a safe manner.
Please take some time to review the following points concerning safe use
of EM Series loudspeakers.
Professional loudspeakers are capable of producing extremely high sound
levels and should be used with care. Hearing loss is cumulative and can
result from levels above 90dB if people are exposed for a long period.
Never stand close to loudspeakers driven at high level.
4.1 Rigging and suspension
W
ARNING: Suspending the system should only be done by qualified
personnel following safe rigging practices. Secure fixings to the
building structure are vital. Seek help from architects, structural
engineers or other specialists if in any doubt.
5 AMPLIFICATION
The EM15 and EM150 are designed to be used with professional power
amplifiers capable of producing the following power outputs into 4 ohms:
EM15 4 ohm 50-100W
EM15 16 ohm 200-400W
EM150 400-500W
Care should be taken to avoid amplifier clipping. It is important to
understand that a low power amplifier driven into clipping is more likely to
damage a loudspeaker than a higher power amplifier used within its ratings.
This is because music signals have a high peak-to-average "crest" factor.
When an amplifier is severely overdriven, its output waveform is clipped
(its peaks are squared off) – reducing the crest factor. In extreme cases,
the waveform can approach that of a square wave. An amplifier is normally
capable of producing far more power under these conditions than its
undistorted rated power output.
The use of very high power amplifiers with outputs greater than those
recommended is discouraged.
Care should be taken to avoid switch-on surges, which can result in
momentary power peaks in excess of specified ratings. When powering up
a sound system it is important to switch on the amplifiers after the mixer
and control electronics have stabilised. When powering down the system,
reverse the sequence and switch off the amplifiers first.
Martin Audio – EM SERIES
ENGLISH
4
All material © 2007. Martin Audio Ltd. Subject to change without notice.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Martin Audio EM15 and is the answer not in the manual?

Martin Audio EM15 Specifications

General IconGeneral
BrandMartin Audio
ModelEM15
CategorySpeakers
LanguageEnglish

Related product manuals