MartinLogan Dynamo 500 - AC Power Connection; Replacing the Fuse; Break-In

8ConnectionsandControlSettings
AC Power Connection Replacing the Fuse
The power cord should be firmly inserted into any conve-
nient AC wall outlet. The Dynamo 500 also integrates a
signal sensing power supply that automatically switches off
aftersensingnomusicsignalforseveralminutes(thiswill
causethestatusLEDtoturnoff).
Your Dynamo 500 subwoofer is wired for the power ser-
vice supplied in the country of original consumer sale. The
AC power rating applicable to a particular unit is specified
both on the packing carton and on the serial number plate
attached to the subwoofer.
If you remove your Dynamo 500 subwoofer from the country
of original sale, be certain that AC power supplied in any
subsequentlocationissuitablebeforeconnectingandoper-
ating the subwoofer. Substantially impaired performance or
severe damage may occur to the Dynamo 500 subwoofer if
operation is attempted from an incorrect AC power source.
IfthefuseinyourDynamo500shouldrequirechanging,
turn off and unplug your Dynamo 500 before removing the
fuse.ReplacethebadfusewithamatchingT1.6AL250V(T
0.8AL250Vifyouareinaregionusing230V).
Break-In
Ourcustommadewoofersrequireapproximately50hours
of break-in at moderate listening levels before their optimal
performance occurs. This will factor in on any critical listening
and judgment.