— 16 —
2. Move the choke lever to the closed ( ) position
3. Move the stop switch to the “ON” position.
4. (1) Press the throttle trigger.
(2) Move the throttle setting lever to half position.
(3) Release the throttle trigger.
(4) Release the throttle setting lever.
(Throttle is kept in half position.)
5. Hold the Handheld Blower with your left hand
and press it down firmly. Hold the assist handle
with your right foot gently.
IMPORTANT: Be careful not make damages to
fuel tank or the blower by your foot.
6. Pull the starter grip. Grasping the starter grip,
slowly pull the starter cord out until you feel resis-
tance, then pull the cord quickly and powerfully.
Pull the starter grip until the engine starts.
7. After the engine starts, move the throttle setting
lever to the idle position, then move the choke
lever to the open ( ) position.
If the engine stops running before you move the
choke lever to the open ( ) position:
A. Go ahead and open the choke.
B. Make sure the throttle setting lever is set to the
idle position.
C. Pull the starter grip until the engine starts.
Starter Grip
Choke Lever
STOP SWITCH
START (ON) STOP
Throttle Trigger
Idle Position
Throttle Setting Lever
Full Throttle
Position
(1)
(2)
Fuel TANK
Assist Handle
WARNING
POTENTIAL HAZARD
• The components of your recoil starter
assembly are under high spring tension.
If improperly disassembled these parts
may strike you with considerable force,
possibly causing personal injuly.
WHAT CAN HAPPEN
• Contact with the parts can cause severe
personal injury.
HOW TO AVOID THE HAZARD
• Never attempt to disassemble your
recoil starter assembly yourself.
Always consult your authorized
Maruyama dealer for repair by qualified
service technicians.
To Next Page
Loading...
