OPERATING INSTRUCTIONS
STARTING PROCEDURE
PRIMER
BULB
FUEL
RETURN LINE
CHOKE
LEVER
CLOSE
OPEN
STARTER GRIP
— 8 —
English
STEP #1)
Pump the "PRIMER BULB" under of the
carburetor until fuel can be seen flowing
through the "FUEL-RETURN LINE".
STEP #2)
Move the "CHOKE LEVER" fully up ward to
the closed position. If the engine is already
warm, only a partial or open (no choke) choke
setting may be required.
STEP #3)
Set the throttle lever at 1/2 speed.
Standard
HIGH SPEED
IDLE SPEED
STOP
CAUTION!
Press down the "AIR FILTER COVER" and Pull the
"STARTER GRIP" briskly to start the engine.
NOTE: Only short pulls are necessary. Never pull the
starter cord to its fullest extension. Never let go of the
starter grip until it is at the fully returned position.
To Next Page
Loading...
