— 6 —
Power Hedge Trimmer safety
1. Shut off the engine and wait unit the cutting blades have completely stopped moving before
checking, maintenance or working on the Hedge Trimmer.
2. Inspect the Hedge Trimmer before each use. Replace damaged parts. Check for fuel leaks.
Make sure all fasteners are in place and tightened securely. Follow the maintenance instruc-
tions provided on page 13 to 15 of this manual.
3. Inspect the Hedge Trimmer cutting blades and guide. Replace any parts that are cracked,
chipped, or damaged before using the Power Hedge Trimmer.
4. Never use replacement parts that are not approved by Maruyama.
5. Maintain the Hedge Trimmer in accordance with the recommended maintenance intervals and
procedures in the maintenance section, pages 13 to 15.
6. If running problems or excessive vibration occur, stop immediately and inspect the unit for the
cause. If the cause cannot be determined or is beyond your ability to correct, return the Hedge
Trimmer to your servicing dealer for repair.
7. Never use the hedge trimmer if handles are damaged or handle fasteners are loose.
Always make sure all fasteners (nuts and bolts) are installed and properly tightened.
8. Never use a machine that has been modified so that it no longer corresponds with the original
design.
9. Do not attempt to repair the Hedge Trimmer unless you are qualified to do so.
10. When transporting or storing the Hedge Trimmer always fit the blade shield.
Fuel safety
1. Gasoline is highly flammable and must be handled and stored
carefully. Use a container approved for storing gasoline and/or
fuel/oil mixture.
2. Mix and pour fuel outdoors and where there are no sparks or flames.
3. Do not smoke near fuel or the Hedge Trimmer or while using the
Hedge Trimmer.
4. Do not overfill the fuel tank. Stop filling 10 ~ 20 mm from the top of
the tank.
5. Wipe up any spilled fuel before starting the engine.
WIPE UP ANY FUEL SPILLAGE
To Next Page
Loading...
